📢 🧮 New calculator: tiered rates and fixed withdrawal fees included 🔥 BTC Dominance: 38.8% 📊 Total Market Cap: $3.28T

Maker and Taker: The Fee Gap That Decides Strategies

Two rates, one schedule

Almost every exchange quotes a pair: a maker rate and a taker rate, with the maker rate lower — sometimes negative. The gap between them is usually larger than the gap between adjacent volume tiers, which makes it the single most consequential number in the schedule and the one most often ignored.

What actually decides which one you pay

You pay taker when your order removes liquidity: a market order, or a limit order that fills immediately against a resting order. You pay maker when your order adds liquidity and waits: a limit order that sits in the book until someone else takes it.

The distinction is decided at execution, not at submission. A limit order can start as maker and end up as taker if it crosses the spread on arrival. That is why two traders using the same order type can pay different rates on the same pair in the same minute.

Why the maker rate can be negative

A negative maker fee is a rebate: the venue pays you for providing liquidity. It exists because liquidity is the product the venue sells to takers. When you see a negative maker rate, the correct reading is not “free trading” — it is that the venue is buying something from you, and it expects to sell it at the taker rate.

This has a practical consequence for strategy design: a market-making strategy’s edge may be entirely the rebate, in which case the strategy is not predicting anything, it is being paid to stand still. That is a legitimate business, but it is a different one, and it dies if the rebate is withdrawn.

The break-even calculation nobody does

If your strategy has an expected edge of a few basis points per trade, the maker/taker choice can be larger than the edge itself. The arithmetic is simple and worth doing once per strategy:

  • Compute the expected edge per round trip, in basis points.
  • Add the taker cost of both legs (entry and exit) if you cross the spread.
  • Compare against the maker cost of both legs, including the probability that a resting order never fills.

The second term is the one people forget: a maker order that does not fill has an implicit cost — the move you missed. Cheap fees on trades you never make are not a saving.

Volume tiers apply to both rates

Ladders usually move the maker and taker rates together, but not by the same amount. At the top of the ladder the two can converge; at the bottom the gap is widest. This means the value of reaching a higher tier is not one number — it depends on your maker/taker mix. A pure taker gains more from a tier upgrade than a pure maker does at the same level.

What this means in practice

  • Know your mix before comparing venues. A venue with a great maker rate and a poor taker rate is not cheap for a taker strategy.
  • Treat the rebate as revenue, not as a discount. If the edge is the rebate, the strategy is exposed to a policy change.
  • Model the unfilled probability. Maker-only strategies pay in missed moves, not in fees.
  • Check whether the rate is decided at submission or execution. It changes how you should size and place orders.

Where to go next

For how the volume ladders that set these rates are built, see how exchange fee tiers actually work. For the inputs a fee calculator needs before any of this arithmetic is trustworthy, see how to use a fee calculator honestly.

The short version

The maker/taker gap is usually bigger than the tier gap. Decide which side you are on before you compare venues, count the cost of orders that never fill, and treat a negative maker fee as revenue with a policy risk attached rather than as a discount.